Why we cut this one
We made this for GoPro and DJI, and for the way that machine actually travels — desk, bag, train table, desk again. the pole locks at each section.
A case is worth its room in the bag for what it stops, and on the GoPro and DJI the part that pays for a knock is the lid. The locking collars are the part that fails first on a cheap pole, so ours are metal and they bite on a wet hand. The shell takes the hit instead, so we would rather it be stiff and slightly dull than soft and pretty.
There is a flat pocket for a slim charger, a cable roll and a key pouch. It sits against the outer wall, so adding a charger does not press anything into the lid of the GoPro and DJI.
The S3C finish is what this listing is — it was measured against GoPro Hero 13/12/11/10/9/8/7/6/5/4/3 Plus/3/Session/GoPro MAX/AKASO EK7000,DJI OSMO Action 5 Pro /4/3/2 Camera.










