Smatree
Why we cut this one
This is our hard cases with a built-in stand made for ASUS P1412. The MS53 pattern is ours. the lid folds back into a wedge, so the fit is a fit and not an approximation.
The hinge is the weak point in most hard cases, so ours is reinforced along the full length and the shell stays square when the lid is open. That matters more on the ASUS P1412 than on most machines, because its lid is the widest flat panel you own and the first thing a dropped bag finds.
Alongside the ASUS P1412 there is room for a brick, two cables and a pass. We would rather give you one honest pocket than four that each hold half a thing.
This one is the MS - White cut in 14 inch. It was measured against ASUS P1412.
