Smatree
Why we cut this one
This is our hard cases with a built-in stand made for HP ProBook 4 G1a. The MS89T pattern is ours. the lid folds back into a wedge, so the fit is a fit and not an approximation.
The point of cutting the MS89T tight to the HP ProBook 4 G1a is simple: The hinge is the weak point in most hard cases, so ours is reinforced along the full length and the shell stays square when the lid is open. Nothing moves, so nothing wears a mark into the corner of the lid.
There is a flat pocket for a slim charger, a cable roll and a key pouch. It sits against the outer wall, so adding a charger does not press anything into the lid of the HP ProBook 4 G1a.
MS - Black in 16 inch, and that is the whole difference between this page and its neighbours. It was measured against 16 inch HP ProBook 4 G1a/G1i,HP EliteBook 6/8 G1i/G1a,EliteBook 8 G2i,ZBook 8 G2a, Waterproof Sleeve.
