Smatree
Why we cut this one
This is our hard cases with a built-in stand made for DELL Latitude 3450. The MS54T pattern is ours. the lid folds back into a wedge, so the fit is a fit and not an approximation.
What we care about is the gap between the DELL Latitude and the wall around it. The hinge is the weak point in most hard cases, so ours is reinforced along the full length and the shell stays square when the lid is open. A machine that slides half an inch inside its own case is a machine that arrives with a dented lid.
Alongside the DELL Latitude there is room for a brick, two cables and a pass. We would rather give you one honest pocket than four that each hold half a thing.
You are looking at the MS - Black version in 14 inch. It was measured against 14 inch DELL Latitude 3450/3440 Laptop, for DELL Vostro 3420 Laptop Notebook Bag.
